null
shop by category

QFS Fuel Cell Electrical Bulkhead Fitting 10GA Wire Fuel Pump Assembly w/ Teflon Washers

$24.98
$17.49
(You save $7.49 )
(No reviews yet) Write a Review
SKU:
QFS-BKCN-01
MPN:
QFS-BKCN-01
Weight:
0.02 LBS

The QFS bulkhead fitting allows [2] 10 gauge wires to pass through the top of the fuel pump assembly or fuel cell, and a 3rd smaller gauge wire can also come through (for fuel level sending units for example).  The QFS bulkhead fitting features E85/gasoline safe PTFE (teflon) washers to seal both the top and bottom of the fitting.  These QFS bulkhead fittings are commonly used when creating dual fuel pump assemblies for late model Silverados, Mustangs, F150s, and other vehicles who's factory bulkhead connector cannot handle the amperage draw of the Walbro 450 fuel pumps.  They are also very useful when installing a Walbro 450 onto a factory or replacement GM square body hanger (see pictures attached).

All Quantum brand products are backed by a lifetime warranty. Quantum products that fail at any time will be replaced under warranty if it is determined that the failure was due to a defect in workmanship or material. This warranty only applies to the original customer and is non-transferable. Improper use or installation of the product voids this warranty, and Quantum is not responsible for incidental costs resulting from failure of the product. In the unlikely event that you should need to request a warranty, please contact us at support@highflowfuel.com with your order information and a detailed description of the problem.